Slave User-Set Allocations Reference Table - Omron CS1W-DRM21 Operation Manual

Allocated DM Area Words
Ranges
Areas and Word Ranges
3-3-7

Slave User-set Allocations Reference Table

Word
Bit 15
m+31
m+32
m+33
m+34
m+35
m+36
m+37
m+38
m+39
m+40
m+41
m+42
Name
OUT block 1/2 area
First word in OUT
block 1/2
No. of bytes in OUT
block 1/2
IN block 1/2 area
First word in IN
block 1/2
No. of bytes in IN
block 1/2
Code
00 Hex ---
01 Hex CIO Area (CIO)
03 Hex Data Memory (DM)
04 Hex Work Area (WR)
05 Hex Holding Relay (HR)
08 to 14 Expansion Data Memory (EM)
Hex Bank 0 to bank C (13 banks)
The slave block settings can be accessed in the Slave User-set Allocations
Reference Table. A maximum of two OUT and two IN areas (OUT 1, IN 1,
OUT 2, and IN 2) can be used for slave communications and their area and
size can be accessed in the table.
The OUT 1 and IN 1 areas and sizes are valid even if a Configurator is not
being used.
Reserved by system
First word in the slave OUT 1 area
OUT 1 area size (bytes)
Reserved by system
First word in slave IN 1
IN 1 area size (bytes)
Reserved by system
First word in the slave OUT 2 area (Always 0)
OUT 2 area size (bytes) (Always 0)
Reserved by system
First word in slave IN 2
IN 2 area size (bytes)
Range
See Areas Shows the area.
and Word
Shows the first word for the block.
Ranges.
0000 to Shows the block size in bytes. The OUT block
03E8 Hex has not been allocated if this is set at 00 Hex.
(0 to 1,000
bytes)
See Areas Shows the area.
and Word
Shows the first word for the block.
Ranges.
0000 to Shows the block size in bytes. The OUT block
03E8 Hex has not been allocated if this is set at 00 Hex.
(0 to 1,000
bytes)
Name
Bit 08 Bit 07
Slave OUT 1 area
Slave IN 1 area
Slave OUT 2 area (Always 0)
Slave IN 2 area
Section 3-3
Details
Word range
The block is not used.
0000 to 17FF Hex (0 to 6143)
0000 to 7FFF Hex (0 to 32767)
0000 to 01FF Hex (0 to 511)
0000 to 01FF Hex (0 to 511)
0000 to 7FFF Hex (0 to 32767) for
all banks
Bit 00
91