Table of Contents
Advertisement
Parameter Displays and Settings
Operation Keys
3-4
Parameter Displays and Settings
3-4-1 Table of Parameters
Display
Parameter
level
0
PV monitor
(see note 3)
Manual output
volume
(see note 6)
Set point (see
note 3)
Bank number
Alarm SV 1 (see
notes 3, 4)
Alarm SV 2 (see
notes 3, 4)
Input shift value
(see note 3)
Proportional band
(see note 1)
Integral (reset)
time (see note 1)
Derivative (rate)
time (see note 1)
24
Name
Level Key
The parameter items are divided into three display groups (Refer
to display levels 0 to 2 in the table below). Press this key to
switch from one group to another. The display levels
automatically cycle in the sequence 0 –> 1 –> 2 –> 0 when the
key is held down for approximately 2 seconds.
Display Key
Press this key to select the required parameter from the selected
display level 0 to 2 (Refer to table below).
The parameters cycle automatically when the key is held down.
Loop Key
Press this key for approximately two seconds to switch between
Loop 1 and Loop 2.
Up Key
Press this key to increment SV.
The SV increment continuously while the key is held down. The
SV display blinks when the value reaches its upper limit.
Down Key
Press this key to decrement an SV.
The SV decreases continuously while the key is held down. The
SV display blinks when the value reaches its lower limit.
Display
Write
Read
symbol
---
No
Yes
Yes
Yes
o
---
Yes
Yes
See
Yes
bk
note 5
Yes
Yes
al–1
Yes
Yes
al–2
Yes
Yes
in–5
Yes
Yes
p
Yes
Yes
i
Yes
Yes
d
Function
Loop
Bank
Data range
no.
no.
Yes
No
Scaling lower
limit –10% to
scaling upper
limit +10%
Yes
No
-5 to 105%
Yes
Yes
Scaling lower
limit to scaling
upper limit
Yes
No
1 to 8
Alarm mode
Yes
Yes
1, 4, 5:
0 to 9999
0 to 9999
Yes
Yes
Other:
–999 to 9999
Yes
Yes
–999 to 9999
Yes
Yes
0.0 to 999.9% FS 10.0% FS
Yes
Yes
0 to 9999 s
Yes
Yes
0 to 9999 s
Section 3-4
Default value
Page
(Unit: EU)
26
0%
26
0 EU
26
1
26
0 EU
27
0 EU
27
27
240 s
40 s
Advertisement
Table of Contents
