Chapter 5: Ip Interface Translations; Inputting Initial System Translations - Avaya S8700 Series Installing And Configuring

Chapter 5: IP interface translations

To administer IPSI circuit packs, use a terminal emulation program to issue Communication
Manager SAT commands.
For Communication Manager terminal emulation, use a program such as Avaya Native
Configuration Manager, Avaya Terminal Emulation, or HyperTerminal.
You also can use Avaya Site Administration to issue SAT commands. To administer some of the
features in the latest release of Avaya Communication Manager, you must use the latest
version of Avaya Site Administration.
Perform these tasks to administer IPSI circuit packs:

Inputting initial system translations

●
Adding media gateways
●
Enabling the IPSI
●
Adding the IPSI to the system
●
Enabling IPSI duplication (duplicated control network only)
●
Setting the alarm activation level
●
Saving translations
●
Inputting initial system translations
1. Open a SAT session. See
2. Enter translations:
If the system translations were prepared offsite, enter the translations and reset the media
server.
If the translations are not available, enter minimal translations to verify connectivity to the
port networks.
3. After you enter the translations, type save translation and press Enter to save the
translations to the hard disk drive.
4. Type reset system 4 and press Enter to have the software read the copied
translations.
Installing and Configuring the Avaya S8700-Series Media Server
on page 41
on page 42
on page 43
on page 44
on page 45
on page 45
Using the SAT command line prompt
on page 45
on page 83.
February 2007
41