Preparing To Configure The Ethernet Switch - Avaya S8700 Series Installing And Configuring

Chapter 2: SNMP Configuration
Table 5: Default values for a dedicated control network
switch 1 and Ethernet switch 2 for a dedicated control network.
For non-dedicated control networks, the customer will provide IP addresses
!
Important:
Do not use the IP address of the active server.
Important:
Table 5: Default values for a dedicated control network
Parameter
IP address
Subnet mask
IP address for the
trap receiver (media server 1)
IP address
Subnet mask
IP address for the
trap receiver (media server 2)

Preparing to configure the Ethernet switch

Before you configure the Ethernet switch, you must complete the following prerequisites:
The Ethernet switch power cord is connected to the back of the switch and to the back of a
●
UPS.
- For a single control network, connect the Ethernet switch 1 for Control Network A
(CNA) into UPS 1.
- For a duplicated control network, connect the Ethernet switch 1 for CNA into UPS 1
and connect the Ethernet switch 2 for Control Network B (CNB) into UPS 2.
The communication protocol on your computer has the following port settings so that you
●
can use your terminal emulation program:
- 9600 baud
- No parity
- 8 data bits
- 1 stop bit
- No flow control
24
Installing and Configuring the Avaya S8700-Series Media Server
shows the default values for Ethernet
Ethernet Single control
switch network (CNA)
1 198.152.254.240
255.255.255.0
1 198.152.254.200
2 198.152.254.241
255.255.255.0
2 198.152.254.200
Duplicated control
network (CNB)
198.152.255.240
255.255.255.0
198.152.255.200
198.152.255.241
255.255.255.0
198.152.255.200
February 2007