Chapter 5: Ip Interface Translations; Inputting Initial System Translations - Avaya S8730 Installing And Configuring

Chapter 5: IP interface translations

To administer IPSI circuit packs, use a terminal emulation program to issue Communication
Manager SAT commands.
For Communication Manager terminal emulation, use a program such as Avaya Native
Configuration Manager, Avaya Terminal Emulation, or HyperTerminal.
You also can use Avaya Site Administration to issue SAT commands. To administer some of the
features in the latest release of Avaya Communication Manager, you must use the latest
version of Avaya Site Administration.
Perform these tasks to administer IPSI circuit packs:

Inputting initial system translations

Adding media gateways
Enabling the IPSI
Adding the IPSI to the system
Enabling IPSI duplication (duplicated control network only)
Setting the alarm activation level
Saving translations
Inputting initial system translations
1. Open a SAT session. See
2. Enter translations:
If the system translations were prepared offsite, enter the translations and reset the server.
If the translations are not available, enter minimal translations to verify connectivity to the
port networks.
3. After you enter the translations, type save translation and press Enter to save the
translations to the hard disk drive.
4. Type reset system 4 and press Enter to have the software read the copied
translations.
Installing and Configuring the Avaya S8700-Series Server
on page 51
on page 52
on page 53
on page 54
on page 55
on page 55
Using the SAT command line prompt
on page 55
on page 94.
January 2008
51