Avaya S8700 Series Installing And Configuring page 50

Chapter 6: IP interface configuration
4. To log into the IPSI, use SSH and the IP address 192.11.13.6.
For information on how to use SSH, see
server with SSH
Note:
While connected to the IPSI, type help or ? to obtain online help. Most
Note:
commands have two or three letter abbreviations.
5. Type ipsilogin and press Enter.
Note:
The craft login used on the IPSI has a different password from the craft login used
Note:
on the media servers.
6. Log in as craft.
Prompt = [IPADMIN]:
7. Type show control interface and press Enter and then type show port 1 and
press Enter to see the current control interface settings.
8. To set the control interface, type set control interface ipaddr netmask and
press Enter, where ipaddr is the customer-provided IP address and netmask is the
customer provided subnet mask.
9. Type quit and press Enter to save the changes and exit the IPSI session.
10. Log back in to the IPSI using SSH.
11. Type show control interface and press Enter.
The system displays IP address, subnet mask, and default gateway information.
Verify that the proper information was entered.
50
Installing and Configuring the Avaya S8700-Series Media Server
on page 77.
Accessing the command line interface of the
February 2007