Avaya S8700 Series Installing And Configuring page 54

Chapter 6: IP interface configuration
Note:
If you pass the letter or number that you want, you have two options. You can
Note:
cycle through all the letters or numbers to get to the one you want. Or, you can
reinsert, or reseat, the circuit pack and start again.
Note:
If you have only one system, the default switch ID is A. The second system is B
Note:
and so on. The switch ID is not the media gateway or carrier letter.
3. While the display characters are flashing, press the button until the switch ID, A through J,
shows on the top character of the LED display. When the correct letter shows, stop. The
letter flashes a few times, or 5 seconds, then stops. The next character down starts to
flash. This is the first digit of the cabinet number.
Note:
The number to program is the cabinet number, not the port network number. If
Note:
you have more than one IPSI in a cabinet, they all have the same cabinet
number.
4. While the first digit of the number is flashing, press the button until the correct tens digit, 0
through 6, for the cabinet number shows on the display. When the correct digit appears,
stop. The digit flashes for about 5 seconds, then stops. Then the second digit starts
flashing.
5. While the second digit is flashing, press the button until the correct units digit, 0 through 9,
for the cabinet number shows on the display. When the correct digit shows, stop. The digit
flashes for about 5 seconds, then stops.
54
Installing and Configuring the Avaya S8700-Series Media Server February 2007