Default Ups Ip Addresses For S8700-Series Media Servers - Avaya S8700 Series Installing And Configuring

Chapter 2: SNMP Configuration

Default UPS IP addresses for S8700-series Media Servers

For how to administer the SNMP module in the UPS, see
page 22. Perform the same steps for each UPS.
dedicated control network
network. For non-dedicated control networks, the customer provides IP addresses.
!
Important:
Do not use the IP address of the active server.
Important:
Table 4: Default UPS IP addresses for a dedicated control network
Parameter
IP address
Subnet mask
Gateway address
IP address for the
trap receiver (media server 1)
IP address
Subnet mask
Gateway address
IP address for the
trap receiver (media Server 2)
!
Important:
Each UPS must report SNMP traps to the media server that the UPS powers.
Important:
If the UPS detects that commercial power is lost or battery resources are depleted, the UPS
sends a trap that allows the media server to lower its state of health and to cause an
interchange. If the UPS sends the trap to the wrong server trap receiver address, that media
server interchanges to the media server that is plugged into the failing UPS. Thus, media server
1 must be plugged into UPS1, and UPS1 must be configured to report SNMP traps to the actual
IP address, and not the active server address, of media server 1. The same requirements apply
to media server 2 and UPS2.
20
Installing and Configuring the Avaya S8700-Series Media Server
shows the default values for UPS1 and UPS2 for a dedicated control
UPS Single control
network (CNA)
UPS 1 198.152.254.239
255.255.255.0
UPS 1 198.152.254.201
UPS 1 198.152.254.201
UPS 2 198.152.254.238
255.255.255.0
UPS 2 198.152.254.201
UPS 2 198.152.254.202
Administering the SNMP modules
Table 4: Default UPS IP addresses for a
Duplicated control
network (CNB)
198.152.255.239
255.255.255.0
198.152.255.201
198.152.255.201
198.152.255.238
255.255.255.0
198.152.255.201
198.152.255.202
on
February 2007