Chapter 8: Installation Verification; Testing The Ipsi Circuit Pack; Testing The License File - Avaya S8700 Series Installing And Configuring

Chapter 8: Installation verification

This chapter provides the following information about how to verify the media server installation
and configuration:
Testing the IPSI circuit packs
●

Testing the license file

●
Checking LED status indicators
●
- Media servers
- Avaya Ethernet switches
- Uninterruptible power supplies (UPSs)
- Circuit packs

Testing the IPSI circuit pack

The following steps test the clock and packet interface components within the TN2312BP IPSI
circuit pack.
Note:
With duplicated media servers, use the active media server.
Note:
1. In a SAT command line, type test ipserver-interface UUC and press Enter,
where UUC is the cabinet and the carrier in which the circuit pack is located.
2. Verify that the Test Results screen shows PASS in the Results column.
Testing the license file
!
Important:
Wait at least 30 minutes after you install the Communication Manager license
Important:
before you run this test.
Note:
With duplicated media servers, use the active media server.
Note:
1. On a SAT command line, type test license and press Enter.
2. Verify that the Test Results screen shows PASS in the Results column.
Installing and Configuring the Avaya S8700-Series Media Server
67
February 2007