Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 73

Table 12: LAG Hashing mechanism for services configured on 7210 SAS-Mxp devices
Services
Epipe service:
SDP to SAP
VPLS service:
SDP to SDP
MPLS – LSR
VPRN service:
SAP to SAP
SAP to SAP (IPv6)
SDP to SAP
SDP to SAP (IPv6)
VPRN service:
SAP to SDP
SAP to SDP (IPv6)
IES service (IPv4):
IES SAP to IES SAP
IES SAP to IES SAP (IPv6)
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide
Packet fields used for Hashing for different traffic types
Non-IP traffic: Source and Destination MAC (Outer MACs
inside the payload, just after the MPLS header), EtherType
IP traffic (Learnt) : Source and Destination MAC (Outer
MACs inside the payload, just after the MPLS header),
Source and Destination L4 ports, VLAN
All other: Source and Destination MAC (Outer MACs inside
the payload, just after the MPLS header)
All traffic: Source and Destination MAC (Outer MACs
inside the payload, just after the MPLS header), Ingress Port-
Id.
All traffic: MPLS label stack (Two labels deep), Source and
Destination IP (only when IP header immediately follows
MPLS header without any Source and Destination MAC in
between inside the MPLS encapsulation), Ingress Port-Id.
Based on Lag sap parameters: service-id, lag_index,
encap_value, service_vlan, sap_index
IP traffic: Source and Destination IP, Source and Destination
L4 ports, Ingress port-Id
Based on Lag sap parameters: service-id, lag_index,
encap_value, service_vlan, sap_index
Interface Configuration
Page 67