Multi-Chassis Redundancy Commands
source-address
Syntax
source-address ip-address
no source-address
Context
config>redundancy>multi-chassis>peer
Description
This command specifies the source address used to communicate with the multi-chassis peer.
Parameters
ip-address — Specifies the source address used to communicate with the multi-chassis peer.
peer-name
Syntax
peer-name name
no peer-name
Context
config>redundancy>multi-chassis>peer
Description
This command specifies the peer name used to communicate with the multi-chassis peer.
Parameters
name — Specifies the name used to communicate with the multi-chassis peer.
sync
Syntax
[no] sync
Context
config>redundancy>multi-chassis>peer
Description
This command enables the context to configure synchronization parameters.
igmp-snooping
Syntax
[no] igmp-snooping
Context
config>redundancy>multi-chassis>peer>sync
Description
This command specifies whether IGMP snooping information should be synchronized with the multi-
chassis peer.
Default
no igmp-snooping
Page 212
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide