Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 140

MDA Commands
Default
MDA 1 is auto-equipped and auto-provisioned by default during bootup.
Parameters
mda-type — The type of MDA selected for the slot postion.
Values
sync-e
Syntax [no] sync-e
Context config>card>mda
Description
This command enables Synchronous Ethernet on the Ethernet ports that support Synchronous Ethernet.
When Synchronous Ethernet is enabled, the timing information is derived from the Ethernet ports.
Synchronous Ethernet is supported for both Ethernet SFP ports and fixed copper ports. It is highly
recommended to use copper port only for distribution of synchronous ethernet and not as a reference.
Refer to the 7210 SAS Basic System Configuration Guide for more information on Synchronous Ethernet.
Default no sync-e
Page 134
7210 SAS-M - m2-xfp|m24-100fx-1gb-sfp|m4-ds1-ces
7210 SAS-Mxp - m22-sfp+2-tx+4-sfpp
7210 SAS-X - m24-1gb+2-10gb
7210 SAS-T - m12-sfp+10-tx+4-xfp
7210 SAS-R6 - imm-sas-10sfp
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide