Ethernet Port Commands
accept-remote-loopback
Syntax
[no] accept-remote-loopback
Context
config>port>ethernet>efm-oam
Description
This command enables reactions to loopback control OAM PDUs from peers.
The no form of this command disables reactions to loopback control OAM PDUs.
Default
no accept-remote-loopback
mode
Syntax
mode {active | passive}
Context
config>port>ethernet>efm-oam
Description
This command configures the mode of OAM operation for this Ethernet port. These two modes differ in that
active mode causes the port to continually send out efm-oam info PDUs while passive mode waits for the
peer to initiate the negotiation process. A passive mode port cannot initiate monitoring activites (such as
loopback) with the peer.
Default
active
Parameters
active — Provides capability to initiate negotiation and monitoring activities.
passive — Relies on peer to initiate negotiation and monitoring activities.
transmit-interval
Syntax
[no] transmit-interval interval [multiplier multiplier]
Context
config>port>ethernet>efm-oam
Description
This command configures the transmit interval of OAM PDUs.
Default
transmit-interval 10 multiplier 5
Parameters
interval — Specifies the transmit interval.
Values
multiplier multiplier — Specifies the multiplier for transmit-interval to set local link down timer.
Values
Page 158
1 — 600 (in 100 milliseconds)
2 — 5
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide