Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 61

Table 10: LAG Hashing mechanism for services configured on 7210 SAS-T Access-Uplink mode
Service and Traffic direc-
tion
Epipe service:
SAP to SAP
IES service (IPv4):
IES SAP to IES SAP
NOTE:
1. The term 'Learnt' mentioned corresponds to Destination MAC.
2. Source/Destination MAC refer to 'Customer Source/Destination MACs' unless otherwise
3. VLAN ID is considered for Learnt - PBB, MPLS, Non-IP traffic in VPLS service only
4. Only outer VLAN tag is used for hashing.
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide
Packet fields used for Hashing for different
traffic types
IIP traffic: Source and Destination IP, Source
and Destination L4 ports, Ingress Port-Id.
PBB traffic: BDA, BSA, ISID, Ingress Port-Id
MPLS traffic (IP): MPLS label stack (Two
labels deep), Source and Destination IP,
Ingress Port-Id
MPLS traffic (L2): MPLS label stack (Two
labels deep), Ingress Port-Id
Non-IP traffic: Source and Destination MAC,
EtherType, Ingress Port-Id, VLAN
IPv4 unicast traffic: Source and Destination
IP, Source and Destination L4 ports.
specified.
for traffic ingressing at dot1q, Q.*, Q1.Q2 SAPs.
Interface Configuration
Page 55