Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 211

mac-address
Syntax mac-address mac-address
no mac-address
Context config>eth-ring>path>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the MEP is on
a SAP) or the bridge (if the MEP is on a spoke SDP).
Parameters
mac-address — Specifies the MAC address of the MEP.
Values
one-way-delay-threshold
Syntax one-way-delay-threshold seconds
Context config>eth-ring>path>eth-cfm>mep
Description
This command enables one way delay threshold time limit.
Default
3 seconds
Parameters
priority — Specifies the value for the threshold in seconds.
Values
shutdown
Syntax [no] shutdown
Context config>eth-ring>path>eth-cfm>mep
Description This command administratively enables or disables the MEP.
The no form of this command disables or enables the MEP.
Default shutdown
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx) of the MEP. Using
the all zeros address is equivalent to the no form of this command.
0 — 600
Interface Configuration
Page 205