Diodes; Foot Switch - Genie Z-34/22 Service Manual

April 2016
1-2

Diodes

How to Test a Diode
1 Connect the leads from an ohmmeter to each
end of the diode.
2 Re-connect the leads from the ohmmeter to
the opposite ends (from step 1) of the diode.
The diode should have resistance in one
direction and not the other.
Part No. 139234
1-3

Foot Switch

How to Test the Foot Switch
1 Turn the key switch to the off position.
Remove the fasteners securing the foot switch
to the platform and remove the bottom cover
from the foot switch.
2 Do not press down the foot switch. Connect
the leads from an ohmmeter or continuity
tester to each wire combination listed on the
next page and check for continuity.
Test
red to black
red to white
black to white
Note: Do not use the color of the connector as a
guide for these tests. Use the actual wire color to
identify which connector to use for testing.
3 Press down the foot switch. Connect the leads
from an ohmmeter or continuity tester to each
wire combination listed below and check for
continuity.
Test
red to black
red to white
black to white
Z-34/22 Bi-Energy
Service Manual
Platform Controls
Desired result
continuity (zero Ω)
no continuity (infinite Ω)
no continuity
Desired result
no continuity (infinite Ω)
no continuity
continuity (zero Ω)
59