Service Manual
Generator
7-1
Generator Pulley
How to Remove the Generator
How to R emove the Generator Pulley
Pulley
1
Loosen the tension adjustment bolt on the
generator.
2
Push the generator towards the machine and
remove the belts from the generator pulley.
3
Remove the generator pulley retaining nut
from the generator shaft.
4
Slide the pulley off of the generator shaft.
5
Loosen the set screw on the pulley bushing,
then slide the pulley bushing off of the
generator shaft.
1 gap
2 shaft
3 set screw
4 engine drive pulley
5 engine drive pulley bolt
6 shaft bushing
7 woodruff key
86
How to Ins tall the Generator Pull ey
How to Install the Generator
Pulley
Note: The pulley on the generator must be installed
before installing the engine drive pulley.
1
Align the woodruff key on the generator shaft
with the slot in the pulley and slide the pulley
all the way onto the generator shaft.
2
Install the flat washer and pulley retaining nut
onto the generator shaft, then torque the nut to
specification. Refer to Specifications,
Generator.
3
Adjust the tension of the generator belts. Refer
to Repair Procedure, How to Adjust the
Generator Belts.
Z-34/22 Bi-Energy
April 2016
Part No. 139234