Routing Resources - Cisco 350XG series Administration Manual

Administration

Routing Resources

Routing Resources
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
• Restore to Factory Defaults—Reboots the device by using the factory
default configuration. This process erases all the files that are stored on the
device except the image files and the language file (e.g. the Startup
Configuration file and the backup configuration file).
The stack unit ID is set to auto.
The mirror configuration file is not deleted when restoring to factory defaults.
• Clear Startup Configuration File—Check to clear the startup configuration
on the device for the next time it boots up.
TCAM entries are divided into the following groups:
• IP Entries—Router TCAM entries reserved for IP static routes, IP interfaces,
and IP hosts.
• Non-IP Entries—TCAM entries reserved for other applications, such as
ACL rules, CoS policers, and VLAN rate limits.
The following table describes the number of TCAM entries used by the various
features:
Logical Entity
IP Neighbor
IP Address on an interface
IP Remote Route
On-Link-Prefix
The Routing Resources page enables you to adjust the Router TCAM allocation.
If you change the router TCAM allocation incorrectly, an error message is
displayed. If your router TCAM allocation is feasible, a message is displayed that
an automatic reboot will be performed with the new settings. Routing resources
can be modified incorrectly, in one of the following ways:
IPv4 IPv6 (PCL
TCAM)
1 entry 1 entry
2 entries 2 entries
1 entry 1 entry
1 Entry
5
IPv6 (Router
TCAM)
4 Entries
8 entries
4 Entries
4 Entries
69