Cisco 350XG series Administration Manual page 252

VLAN Management
VLAN Groups
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
Protocol-Based Groups
To define a set of protocols.
Click VLAN Management > VLAN Groups > Protocol-Based Groups.
The Protocol-Based Groups Page contains the following fields:
• Encapsulation—Displays the protocol on which the VLAN group is based.
• Protocol / DSAP-SSAP—Displays the protocol value in hex.
• Group ID—Displays the protocol group ID to which the interface is added.
Click the Add Button. The Add Protocol-Based Group page appears
Enter the following fields:.
• Encapsulation—Protocol Packet type. The following options are available:
- Ethernet V2—If this is selected, select the Ethernet Type.
- LLC-SNAP (rfc1042)—If this is selected, enter the Protocol Value.
- LLC—If this is selected, select the DSAP-SSAP Values.
• Ethernet Type—Select the Ethernet type for Ethernet V2 encapsulation. This
is the two-octet field in the Ethernet frame used to indicate which protocol is
encapsulated in the payload of the Ethernet packet) for the VLAN group
• Protocol Value—Enter the protocol for LLC-SNAP (rfc 1042)encapsulation.
• Group ID—Enter a protocol group ID.
Click Apply. The Protocol Group is added, and written to the Running
Configuration file.
Protocol-Based Groups to VLAN Mapping
To map a protocol group to a port, the port must be in General mode and not have
DVA configured on it (see
Several groups can be bound to a single port, with each port being associated to
its own VLAN.
It is possible to map several groups to a single VLAN as well.
Interface Settings).
12
243