Cisco 350XG series Administration Manual page 93

Administration: File Management
File Operations
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
SSH Client Authentication—Client authentication can be done in one of the
following ways:
• Use SSH Client System Credentials—Sets permanent SSH user
credentials. Click System Credentials to go to the SSH User Authentication
page where the user/password can be set once for all future use.
• Use SSH Client One-Time Credentials—Enter the following:
- Username—Enter a username for this copy action.
- Password—Enter a password for this copy.
• Server Definition—Select whether to specify the SCP server by IP address
or by domain name.
• IP Version—Select whether an IPv4 or an IPv6 address is used.
• IPv6 Address Type—Select the IPv6 address type (if used). The options
are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—Select the link local interface from the list.
• Server IP Address/Name—Enter the IP address or name of the SCP server.
• Destination File Name—Enter the name of the backup file.
• Sensitive Data Handling—Select how sensitive data should be included in
the backup file. The following options are available:
- Exclude—Do not include sensitive data in the backup.
- Encrypt—Include sensitive data in the backup in its encrypted form.
- Plaintext—Include sensitive data in the backup in its plaintext form.
The available sensitive data options are determined by the current
NOTE
user SSD rules. For details, refer to Secure Sensitive Data Management >
SSD Rules page.
6
88