Cisco 350XG series Administration Manual page 609

SNMP
Overview
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
The following is the recommended series of actions for configuring SNMP:
If you decide to use SNMPv1 or v2:
Navigate to the Communities
associated with access rights and a view in Basic mode or with a group in
Advanced mode. There are two ways to define access rights of a community:
• Basic mode—The access rights of a community can configure with Read
Only, Read Write, or SNMP Admin. In addition, you can restrict the access to
the community to only certain MIB objects by selecting a view (defined in the
Views page).
• Advanced Mode—The access rights of a community are defined by a group
(defined in the
security model. The access rights of a group are Read, Write, and Notify.
Choose whether to restrict the SNMP management station to one address or allow
SNMP management from all addresses. If you choose to restrict SNMP
management to one address, then input the address of your SNMP Management
PC in the IP Address field.
Input the unique community string in the Community String field.
Optionally, enable traps by using the
Optionally, define a notification filter(s) by using the
Configure the notification recipients on the
pages.
If you decide to use SNMPv3:
Define the SNMP engine by using the
unique Engine ID or use the default Engine ID. Applying an Engine ID configuration
clears the SNMP database.
Optionally, define SNMP view(s) by using the
OIDs available to a community or group.
Define groups by using the
Define users by using the
If the SNMP Engine ID is not set, then users may not be created.
page and click Add. The community can be
Groups page). You can configure the group with a specific
Trap Settings
SNMP Engine ID
Groups page.
Users page , where they can be associated with a group.
page.
Notification Filter
SNMPv1,2 Notification Recipients
.
page Either create a
Views page. This limits the range of
27
page.
589