Configurable Elements Of Vrrp - Cisco 350XG series Administration Manual

IP Configuration: VRRP

Configurable Elements of VRRP

Configurable Elements of VRRP
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
In this topology, two virtual routers are configured. For virtual router 1, rA is the
owner of IP address 192.168.2.1 and is the virtual router master, and rB is the
virtual router backup to rA. Clients 1 and 2 are configured with the default gateway
IP address of 192.168.2.1.
For virtual router 2, rB is the owner of IP address 192.168.2.2 and virtual router
master, and rA is the virtual router backup to rB. Clients 3 and 4 are configured with
the default gateway IP address of 192.168.2.2.
A virtual router must be assigned an unique virtual router identifier (VRID) among
all the virtual routers on the same LAN. All VRRP routers supporting the same
virtual router must be configured with all the information relating to the virtual
router including its VRID. Virtual routers should be enabled on the device only
when IP routing is also enabled on the device.
You can configure a VRRP router to participate in one or more virtual routers either
by using CLI commands, or through the web GUI, as described in the
VRRP section.
To configure a virtual router, you configure its information, such as the virtual router
ID and its IP addresses, on every VRRP routers that support the virtual router. The
following elements can be configured and customized.
Virtual Router Identification
Virtual Router Identification
It must be assigned an identifier (VRID) and may be assigned a description. The
sections below describe the various attributes of the virtual router.
VRRP supports up to 255 virtual routers (VRRP groups).
VRRP Versions
The device supports the following VRRP version types:
• IPv4 VRRPv3 based on RFC5798. VRRPv3 messages are sent.
18
Configuring
381