Cisco 350XG series Administration Manual page 563

Access Control
IPv4-based ACL Creation
STEP 3
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
Click Add.
Enter the parameters.
• ACL Name—Displays the name of the ACL.
• Priority—Enter the priority. ACEs with higher priority are processed first.
• Action—Select the action assigned to the packet matching the ACE. The
options are as follows:
Permit
- —Forward packets that meet the ACE criteria.
- Deny —Drop packets that meet the ACE criteria.
Shutdown
- —Drop packet that meets the ACE criteria and disable the port
to which the packet was addressed. Ports are reactivated from the
Recovery Settings
• Logging—Select to enable logging ACL flows that match the ACL rule.
• Time Range—Select to enable limiting the use of the ACL to a specific time
range.
• Time Range Name—If Time Range is selected, select the time range to be
used. Time ranges are defined in the
• Protocol—Select to create an ACE based on a specific protocol or protocol
ID. Select Any (IPv4) to accept all IP protocols. Otherwise select one of the
following protocols from the drop-down list Selected from list:
- ICMP —Internet Control Message Protocol
IGMP
- —Internet Group Management Protocol
IP in IP
- —IP in IP encapsulation
- TCP —Transmission Control Protocol
EGP
- —Exterior Gateway Protocol
IGP
- —Interior Gateway Protocol
- UDP —User Datagram Protocol
HMP
- —Host Mapping Protocol
RDP
- —Reliable Datagram Protocol.
- IDPR —Inter-Domain Policy Routing Protocol
page.
System Time Configuration
25
Error
section.
543