Cisco 350XG series Administration Manual page 624

SNMP
Notification Recipients
STEP 4
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
• Recipient IP Address/Name—Enter the IP address or server name of
where the traps are sent.
• UDP Port—Enter the UDP port used to for notifications on the recipient
device.
• Notification Type—Select whether to send traps or informs. If both are
required, two recipients must be created.
• Timeout—Enter the amount of time (seconds) the device waits before re-
sending informs/traps. Timeout: Range 1-300, default 15
• Retries—Enter the number of times that the device resends an inform
request. Retries: Range 1-255, default 3
• User Name—Select from the drop-down list the user to whom SNMP
notifications are sent. In order to receive notifications, this user must be
defined on the
• Security Level—Select how much authentication is applied to the packet.
The Security Level here depends on which User Name was selected.
NOTE
If this User Name was configured as No Authentication, the Security Level is
No Authentication only. However, if this User Name has assigned
Authentication and Privacy on the
screen can be either No Authentication, or Authentication Only, or
Authentication and Privacy.
The options are:
No Authentication
-
encrypted.
Authentication
-
Privacy
- —Indicates the packet is both authenticated and encrypted.
• Notification Filter—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the
Filter page.
• Filter Name—Select the SNMP filter that defines the information contained
in traps (defined in the
Click Apply. The SNMP Notification Recipient settings are written to the Running
Configuration file.
Users page, and its engine ID must be remote.
Users
—Indicates the packet is neither authenticated nor
—Indicates the packet is authenticated but not encrypted.
Notification Filter
page, the security level on this
Notification
page).
27
604