Lldp Properties - Cisco 350XG series Administration Manual

Administration: Discovery
Configuring LLDP
STEP 1
STEP 2
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
LLDP Configuration Workflow
Following are examples of actions that can be performed with the LLDP feature
and in a suggested order. You can refer to the LLDP/CDP section for additional
guidelines on LLDP configuration. LLDP configuration pages are accessible under
the LLDP and CDP section.
1. Enter LLDP global parameters, such as the time interval for sending LLDP
updates using the
2. Configure LLDP per port by using the
interfaces can be configured to receive/transmit LLDP PDUs, send SNMP
notifications, specify which TLVs to advertise, and advertise the device's
management address.
3. Create LLDP MED network policies by using the
page.
4. Associate LLDP MED network policies and the optional LLDP-MED TLVs to the
desired interfaces by using the
5. If Auto Smartport is to detect the capabilities of LLDP devices, enable LLDP in
the Properties page.
6. Display overloading information by using the

LLDP Properties

The Properties page enables entering LLDP general parameters, such as
enabling/disabling the feature globally and setting timers.
To enter LLDP properties:
Click Administration > Discovery - LLDP > Properties.
Enter the parameters.
• LLDP Status—Select to enable LLDP on the device (enabled by default).
• LLDP Frames Handling—If LLDP is not enabled, select the action to be taken
if a packet that matches the selected criteria is received:
Filtering
- —Delete the packet.
Flooding
- —Forward the packet to all VLAN members.
• TLV Advertise Interval—Enter the rate in seconds at which LLDP
advertisement updates are sent, or use the default.
LLDP Properties page.
Port Settings
LLDP MED Port Settings
page. On this page,
LLDP MED Network Policy
page.
LLDP Overloading page.
9
130