Ipv4 Management And Interfaces; Ipv4 Interface - Cisco 350XG series Administration Manual

IP Configuration

IPv4 Management and Interfaces

IPv4 Management and Interfaces
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
Configuring a Loopback Interface
To configure an IPv4 loopback interface, do the following:
• Add a loopback interface in IP Configuration > IPv4 Management and
Interfaces > IPv4 Interface.
To configure an IPv6 loopback interface, do the following:
• Add a loopback interface in IP Configuration > IPv6 Management and
Interfaces > IPv6 Interface. Configure the IPv6 address of that interface in
the IPv6 Addresses
This section covers the following topics:
•

IPv4 Interface

• IPv4 Routes
• RIPv2
• Access Lists
• VRRP
• ARP
• ARP Proxy
• UDP Relay/IP Helper
• DHCPv4 Snooping/Relay
• DHCP Server
IPv4 Interface
The IPv4 Interface page is used to configure IP addresses for device
management. This IP address can be configured on a port, a LAG, VLAN or
loopback interface.
page.
16
309