Projection Stops Automatically; "Not Supported" Is Displayed; "No Signal" Is Displayed - Epson EB-5535U User Manual

Problem Solving

Projection stops automatically

Check
Is Sleep Mode set to On?
Is A/V Mute Timer set to On?

"Not supported" is displayed

Check
Do the image signal resolution and the refresh rate correspond to the
mode?
(Only when projecting computer images)

"No Signal" is displayed

Check
Are the cables connected correctly?
Is the correct port selected?
Is the power for the computer or video source turned on?
Press the [ ] button on the remote control or the [t] button on the control panel to turn on the projector. If you do not
want to use Sleep Mode, change the setting to Off.
s Extended - Operation - Sleep Mode
Press the [ ] button on the remote control or the [t] button on the control panel to turn on the projector. If you do not
want to use A/V Mute Timer, change the setting to Off.
s Extended - Operation - A/V Mute Setting - A/V Mute Timer
Refer to the computer's documentation for how to change the image signal resolution and the refresh rate output from
the computer.
s "Supported Monitor Displays" p.209
Check that all the cables required for projection are securely connected.
Check that no cables are disconnected and that there are no poor contacts in the cables.
Change the image by pressing the [Search] button.
s "Automatically Detecting Input Signals and Changing the Projected Image (Source Search)"
Turn the power on for the equipment.
Remedy
p.122
p.122
Remedy
Remedy
166
p.52