Reading The Indicators - Epson EB-5535U User Manual

Reading the Indicators

The projector is provided with the following five indicators that indicate the operating status of the projector.
The following indicator status are used during regular operation.
Indicator
Power Status Lamp
Blue - On Off Off
Blue -
Blue - On Status
Flashing
varies
Projector's Sta-
tus
Temp Filter
Standby condition
Off Off
Network monitor‐
ing status
Warm-up status
Off Off
A
Power indicator
Indicates the projector's status.
B
Status indicator
Indicates the projector's status.
C
Lamp indicator
Indicates the projection lamps status.
D
Temp indicator
Indicates the internal temperature status. This is normally turned off.
E
Filter indicator
Indicates the air filter status. This is normally turned off.
Power is being supplied to the projector. In this status, you can start projecting by pressing the [
on the remote control or [t] button on the control panel.
(Sometimes, when the power cord is unplugged, the power indicator remains lit for a short period, but this
is not a fault.)
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On).
If the power cord is disconnected and then reconnected in this status, the power indicator flashes blue.
This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds
after the lamp turns on.
The [t] button is disabled during warm-up.
Explanation
151
] button