Problems Relating To Images; No Images Appear; Projection Stops Automatically - Epson EMP-S3L User Manual

Problem Solving

Problems relating to images

No images appear

Check
Was the [Power] button pressed?
Are both indicators switched off?
Is A/V Mute mode active?
Have the configuration menu settings
been made correctly?
Is the projected image completely black?
Only when projecting computer images
Are the image signal format settings
correct?
Only when projecting images
from a video source

Projection stops automatically

Check
Is "Sleep Mode" set to "ON"?
Press the [Power] button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally. Connect the
projector's power cable correctly.
Check that your power supply socket is working.
Press the [A/V Mute] button on the remote control to cancel the mute.
Reset all of the settings. "Reset" - "Reset All"
Some input images, such as screen savers, may be completely black.
If a composite videog or S-Videog
command to select the signal format. "Signal" - "Video Signal"
When the "Sleep Mode" menu command has been set to "ON," the lamp turns off automatically if no
buttons are pressed for about 30 minutes while no video signal is being input. The Power indicator is lit
orange at this time. Press the [Power] button to turn the power on. If you do not want sleep mode to be
used, change the "Sleep Mode" setting to "OFF." "Extended" - "Operation" - "Sleep Mode"
Remedy
(See the Quick Setup sheet)
sp.41
source is connected to the projector, use the "Video Signal" menu
sp.36
Remedy
sp.22
sp.39
49