Epson EB-5535U User Manual page 5

Safety Warning and Cautions
Attention
• When projecting with the projector tilted, do not tilt it at more than the
specified angle. This may cause malfunctions or accidents to occur.
Angle of tilt
Vertical: Tilt up to ±30˚. If you use the projector tilted at an angle of more
than 30˚ it could be damaged and cause an accident.
30
30
Horizontal: Can be tilted within the range of expansion and contraction for
the rear feet.
• Using the projector at an improper angle or setting the Configuration menu
incorrectly causes malfunctions and shortens the operating life of optical
parts.
Attention
• Make sure there is a gap as shown in the following illustration between the
wall and the air exhaust vent and the air intake vent.
• When setting up multiple projectors, make sure there is a gap of at least
50 cm between the projectors. Also, make sure that the heat from the air
30
exhaust vent does not go into the air intake vent.
30
• Do not place the projector directly on top of another projector.
a
Air exhaust vent Air intake vent
• The image is unstable immediately after turning on the projector.
After starting projection, do not touch the projector for at least 30
minutes, and then adjust the focus, zoom, and lens shift.
• When adjusting the image height with the vertical lens shift, adjust
by moving the image from the bottom to the top. If it is adjusted
from the top to the bottom, the image position may move down
slightly after adjusting.
5