Defective Flash Detected [51]; Disk Must Be Formatted For Use In This Device; Error Reading Usb Drive. Remove Usb; Error Reading Usb Hub. Remove Hub - Konica Minolta bizhub 4020 Service Manual


Cancel the current print job. For non-touch-screen printer models, press [OK] to confirm.

Install additional printer memory.

4.4.12 Defective flash detected [51]

Try one or more of the following:

Replace the defective flash memory card.

From the printer control panel, select Continue to ignore the message and continue printing. For
non-touch-screen printer models, press [OK] to confirm.

Cancel the current print job.

4.4.13 Disk must be formatted for use in this device

From the printer control panel, select Format disk to format the printer hard disk and clear the
message. For non-touch-screen printer models, press [OK] to confirm.
Note: Formatting deletes all the files stored in the printer hard disk.

4.4.14 Error reading USB drive. Remove USB.

An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.

4.4.15 Error reading USB hub. Remove hub.

An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.

4.4.16 Fax partition inoperative. Contact system administrator.

Try either of the following:

From the printer control panel, select Continue to clear the message. For non-touch-screen printer
models, press [OK] to confirm.

Turn the printer off, and then turn it back on. If the message appears again, then contact your
system support person or see the "Setting up the printer to fax" section of the User's Guide.
4.4.17 Fax server 'To Format' not set up. Contact system
administrator.
Try either of the following:

From the printer control panel, select Continue to clear the message. For non-touch-screen printer
models, press [OK] to confirm.

Complete the Fax Server setup. If the message appears again, then contact your system support
person.

4.4.18 Fax Station Name not set up. Contact system administrator.

Try either of the following:

From the printer control panel, select Continue to clear the message. For non-touch-screen printer
models, press [OK] to confirm.
bizhub 4020/3320 Service Manual
- 98 -