A5 Loading; Ui Automation; Les Applications (Bizhub 4020 Only); Key Repeat Initial Delay - Konica Minolta bizhub 4020 Service Manual

The Standby mode enables the printer:

To consume less energy than when operating in normal mode but not as little as when operating in
Power saver.

To return to the Ready state more quickly than when operating in power saver. If set to Off, this
setting disables Standby mode in the General settings menu.

5.2.33 A5 Loading

This determines the orientation used when printing on A5 paper.
Available options:

Short Edge—The printer will print A5-size paper in the short-edge feed orientation from the
following tray.
- Multipurpose feeder
- Standard tray (Tray 1)
- Optional tray (Tray 2, 3, 4, 5)

Long Edge—The printer will print A5-size paper in the long-edge feed orientation from the following
tray.
- Multipurpose feeder
- Standard tray (Tray 1)

5.2.34 UI Automation

Once enabled, this setting creates an ENABLE_UI_AUTOMATION file in the /var/fs/shared/ directory.
As long as this file exists, the printer permits external developers to test the stability of their applications
against the printer to make sure that their applications have an appropriate level of stability. Disabling
this setting deletes the file and prohibits automated testing.
To change the setting:
1. From the Configuration menu, navigate to UI Automation.
2. Select from the available options to change the setting.
- Enable
- Disable (default)
3. Depending on the printer model, press OK or touch
the Configuration menu without saving any changes.

5.2.35 LES Applications (bizhub 4020 only)

Note: This menu is displays for the bizhub 4020 only and it is not used.

5.2.36 Key Repeat Initial Delay

Note: This setting is available on the bizhub 4020 only.
This setting determines the length of delay before a repeating key starts repeating. The range is 0.25–5
seconds, with increments of 0.25. The default setting is one second.
bizhub 4020/3320 Service Manual
- 219 -
to save the setting, or press X to return to