Wipe All Settings; Font Sharpening; Reduced Curl; Require Standby - Konica Minolta bizhub 4020 Service Manual

Available options:

Single Pass Erase—overwrites all data and the file system. This wipe is faster but less secure since
it is possible to retrieve the deleted data with forensic data-retrieval techniques.

Multi Pass Erase—overwrites all data without rewriting the file system. This wipe is DoD 5220.22-M
compliant since the deleted data is irretrievable.
Note: If the printer is reset while a disk wipe operation is executing, then Corrupt Disk appears upon
regaining power.

5.2.29 Wipe All Settings

Note: This menu is available on the bizhub 3320 only.
This makes any sensitive information that may exist on the volatile or non-volatile storage of the device
completely indecipherable. When selected, the printer performs a non-critical NVRAM reset and then
reboots.

5.2.30 Font Sharpening

This allows a user to set a text point-size value below which the high-frequency screens will be used
when printing font data.
Available options: 1 to 150

Off

On

5.2.31 Reduced Curl

When on, this setting significantly reduces throughput and should be activated only as a last resort to
solve paper curl problems. The printer uses this mode only when the media type is set to Paper.
Available options:

Off

On

5.2.32 Require Standby

Note: This menu is available on the bizhub 4020 only.
This sets Standby Mode to On or Off. The default is On.
To change the setting:
1. From the Configuration menu, navigate to Require Standby.
2. Select On or Off to change the setting.
3. Depending on the printer model, press OK or touch
the Configuration menu without saving any changes.
If Standby mode is On, the printer begins functioning in Standby mode when it remains idle for an
amount of time.
bizhub 4020/3320 Service Manual
- 218 -
to save the setting, or press X to return to