bizhub 4020/3320 Service Manual
2. Remove the right cover. See
Right cover
removal.
3. Remove the rear door and cover. See
Rear exit door removal
and
Rear cover
removal.
4. Remove the power supply. See
Power supply
removal.
5. Remove the power supply shield. See
Power supply shield
removal.
6. Remove the duplex. See
Duplex
removal.
7. Disconnect the cable JDUPPI 1 from the controller board.
8. Remove the two screws (A), and cut the cable near the frame to detach the sensors.
- 306 -