Changing The Interface Parameters; Changing Parallel Interface Mode - Sagem 5890dn Print Functions

Changing the Interface Parameters

The printer is equipped with both parallel and USB interfaces. Optional serial
interface board kit and network interface card can also be installed. Various printing
environment parameters such as the default emulation can be changed
independently on different interfaces by using the printer's menu selection system.
Select the interface to apply the changes in the procedure described below.
Note : This interface selection described below does not select the interface from which
data will be received. The printer automatically selects the interface.

Changing Parallel Interface Mode

Note : Pour assurer le bon fonctionnement de votre terminal, vous devez impérativement
garder l'option AUTO pour le paramétrage de l'interface parallèle.
The parallel interface supports a bi-directional/high-speed mode according to IEEE
standards. Normally, this interface is used under the default setting Auto. After
setting the interface, be sure to reset the printer or turn the power off at least once.
The new setting will be enabled thereafter. You can select from the following:
• Auto (default)
• Nibble/high speed
• High speed
• Normal
Press [MENU].
Press or repeatedly until Interface > appears.
If the interface is other than parallel, press [OK]. A blinking question mark (?)
appears.
Press or repeatedly untilParallel appears.
Press [OK] again. The question mark disappears.
To change the parallel interface mode, press
mode appears.
To change the communication mode, press [OK]. A blinking question mark (?)
appears.
Press or to scroll through the following communication modes:
- Nibble (high)
- Auto
- Normal
- High Speed
When the desired communication mode is displayed, press [OK].
Press [MENU] to exit the menu selection.
3-27
Using the Operator Panel
. The current communication