Changing Network Interface Parameters - Sagem 5890dn Print Functions

Using the Operator Panel

Changing Network Interface Parameters

This printer supports TCP/IP, NetWare and Appletalk protocols :
• Activate or deactivate TCP/IP, NetWare, and AppleTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
• Determine whether to print a network status page when the printer is turned on
Press [MENU].
Press or repeatedly until Interface > appears.
If the current interface is other than network, press [OK]. A blinking question
mark (?) appears.
Press or repeatedly until Network appears.
Press [OK] again.
Press . One of the following menus is indicated. To change settings for the
item, press [OK]. Use
Set this item to On when you connect to a network using NetWare. In submenu
(>), frame mode can be selected from Auto, 802.3, Ethernet-II, and 802.2.
Set this item to On when you connect to a network using TCP/IP. Submenu
(>) has items including DHCP, BOOTP, IP address, subnet mask address,
and gateway address. To resolve IP address for the network card, See
"Resolving IP Address", page 3-29. Appletalk must be activated (On) for
networking with Macintosh computers.
When the item is set to On, the printer prints out a network status page when
it prints the printer status. See "Printing a Network Interface Status Page",
page 3-29.
Activate the appropriate protocol that is required to connect the printer to the
network. To activate a protocol, display the protocol, press [OK], press or to
change from Off to On, and press [OK].
Press [MENU]. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway
address have been properly set. To print a network status page, See "Printing
a Network Interface Status Page", page 3-29.
or to change the value or selection.
3-28