Table of Contents
Advertisement
Using the Operator Panel
Status Information
Message
Self test
Please wait
Please wait
(Adding toner)
Ready
Processing
Sleeping
Cancelling data
Waiting
FormFeed TimeOut
Error codes
See the Troubleshooting section in the terminal user guide.
The printer is performing self-diagnostics after power-up.
The printer is warming up and is not ready.
When the printer is switched on for the first time, this message will take
several minutes.
Toner is currently being replenished. This message may be displayed
during continuous printing of a large volume of pages which require a
large amount of toner such as with photographs, etc.
The printer is ready to print.
The printer is receiving data to print. This is also shown when the
printer is reading a memory card, hard disk or RAM disk.
The printer is in Auto Sleep. The printer wakes from Auto Sleep
whenever a key on the operator panel and [GO] is pressed, the cover
is opened or closed, or a print job is received. The printer then warms
up and goes on-line. For details on Auto Sleep, See "Sleep Timer
Timeout Time", page 3-65
Cancelling data Jobs inside the printer are being canceled. To cancel
a job, See "Canceling a Printing Job", page 3-10
The printer is waiting for the rest of print job before completing the last
page. Pressing [GO] allows you to obtain the last page immediately.
See below.
The printer is printing the last page after a waiting period.
3-4
Meaning
Advertisement
Table of Contents
