Using Proof-And-Hold - Sagem 5890dn Print Functions

Using the Operator Panel
Deleting a Quick Copy Job

Using Proof-and-Hold

When you print multiple copies, this mode first prints one copy so that you can proof
it before continuing to print the remaining copies. Since you can proof the printouts
before printing the remaining copies, wastage of paper can be reduced.
The printer prints one copy and, at the same time, saves the print job on the hard
disk/RAM disk. You can also change the number of copies when resuming printing
from the operator panel.
When the printer is turned off, all stored jobs will be deleted.
Printing Remaining Copies of a Proof and Hold Job
Printing a Proof-and-Hold job on the operator panel is similar to printing a quick copy
job. See "Printing Additional Copies using Quick Copy", page 3-19.
Press [OK]. A blinking question mark (?) appears before the user name.
Press or to display the desired user name, Arlen, in this example.
Press [OK]. The job name entered in the printer driver (Report, in this
example) appear with a blinking question mark (?) before the letters.
Press or to scroll to the desired job title.
Press [OK]. The number of copies to be printed can be set. To increase the
copy count, Press ; to decrease the copy count, press
Press [OK] to finalize the copy count. The printer prints the specified number
of copies for the job.
Follow steps 1 through 8 in the above section to let the title of the job to be
deleted displayed.
When the title of the job to be deleted is displayed, e.g. Report, press [OK].
The cursor below the copy count starts to blink.
Press repeatedly until Delete appears below the title.
Press [OK]. The stored quick copy job is deleted.
3-20
.