Printing A Network Interface Status Page - Sagem 5890dn Print Functions

Resolving IP Address
To connect the printer to the network using TCP/IP protocol, you must set the IP
address on the printer. The IP address must be unique to the printer and should be
obtained from your network administrator.
Activate TCP/IP protocol in the manner described above.
Enter the submenu by pressing . Each time you press
changes.
When >>IP Address is displayed, press [OK]. A blinking cursor (_) appears at
the last digit.
Press
cursor. Use
When the IP address is entered, press [OK].
Press
complete entering the subnet mask address.
Then, press
complete entering the gateway address.
Press [MENU]. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway
address have been properly set. To print a network status page, See "Printing
a Network Interface Status Page", page 3-29.

Printing a Network Interface Status Page

You can have your printer print out a network status page when the printer prints the
status page. The network status page shows the network addresses, and other
information under various network protocols about the network interface card. The
default setting is Off (print disable).
Note : Printing out a network interface status page may not be possible with the optional
network interface card. For details, see the manual for Interface the network inter-
face.
Press [MENU].
Press [OK] repeatedly until Interface > appears.
If the interface is other than network, press [OK]. A blinking question mark (?)
appears.
Press
Press
Status Page.
The default setting is Off. If it is set to On, press [OK]. A blinking question mark
(?) appears.
or to increase or decrease, respectively, the value at the blinking
and to move the cursor right and left.
or to move to Subnet Mask. Perform the same procedure to
or to move to Gateway. Perform the same procedure to
or repeatedly until Network appears. Press [OK].
and then press or
3-29
Using the Operator Panel
repeatedly until the display shows >Network
or , the selection