Printer Resetting; Resource Protection - Sagem 5890dn Print Functions

Using the Operator Panel

Printer Resetting

The procedure described below resets the printer's temporary conditions, such as
the current page orientation, font, etc., set by commands to their default values.
Downloaded fonts and macros are deleted from the printer's memory.

Resource Protection

By default, when you switch from the PCL 6 emulation to another, all downloaded
fonts and macros will be lost. Resource protection preserves these PCL resources
in memory so that they remain intact even when you have switched back in PCL 6.
Note : Resource protection requires extra memory to store the downloaded fonts and
macros. The total size of the printer memory recommended for using the resource
protection option is affected by several factors. See "Expansion Memory Modules",
page 4-3.
By default, resource protection is deactivated.
Press [MENU].
Press or until Others > appears.
Press .
Press or repeatedly until >Restart Printer appears.
To reset the printer, press [OK]. A question mark (?) appears.
Press [OK] again. Self test appears while the printer is resetting itself, followed
by Please wait and then Ready.
Press [MENU].
Press or repeatedly until Others > appears.
Press .
Press or repeatedly until >Resource Prot. appears.
Press [OK]. A blinking question mark (?) appears.
Press or to select Permanent or Perm / Temp (Permanent/ Temporary)
for resource protection.
When the desired resource protection is displayed, press [OK].
To exit the menu selection, press [MENU].
3-66