Overriding Difference Between A4 And Letter - Sagem 5890dn Print Functions

Using the Operator Panel
Duplex printing can be also performed from the MP tray. When the MP tray is set to
First Mode (First), the paper size and paper type will be the same as those of the
paper cassette currently set at the paper feed source. If the paper to be fed from the
MP tray does not match the paper size and paper type of the current paper feed
source cassette, a paper jam may occur.
Binding Modes
Binding refers to the manner in which printed pages of paper are joined together (by
gluing, stitching, etc.) in book form. The two possible types of binding are: long-edge
binding, in which pages are joined together along their long edge; and short-edge
binding, in which they are joined together along their short edge. In selecting a
binding type, you must also consider the orientation of the printed page. You can use
long-edge or short-edge binding with either landscape or portrait printing.
Depending on the binding type and print orientation, the duplexer provides four types
of binding. These are: (1) portrait, long-edge, (2) portrait, short edge, (3) landscape,
long-edge, and (4) landscape, short-edge. The figure below shows these binding
methods.

Overriding Difference between A4 and Letter

When the Override A4/LT is turned on using the operator panel, the printer ignores
the difference between A4 and Letter paper sizes. Printing is performed without an
error message even if the actual paper size in the current cassette differs from the
paper size formatting the job.
By default, this feature is off.
(1)
Portrait,
long-edge
(3)
Landscape,
long-edge
Press [MENU].
Press or repeatedly until Paper Handling > appears.
Press .
(2)
(4)
3-58
Portrait,
short-edge
Landscape,
short-edge