Reading Data; Writing Data - Sagem 5890dn Print Functions

Reading Data

You can print out the data in the memory card.
Press [MENU].
Press
Press
Press
Press [OK]. A blinking question mark (?) appears before the data name.
Press
Press [OK]. Processing appears and the reading of data from the memory
card starts.

Writing Data

Data can be written to a memory card until the card is full. When writing to a memory
card, a name is assigned to the file automatically. You can use the procedure
explained in the section "Printing a List of Data Names (Partitions)", page 46 to print
a list of data names for confirmation.
Note : First check that the memory card is properly formatted. Otherwise, the >Write Data
message to be explained below will not be shown on the message display. If the
memory card inserted in the memory card slot is not formatted, >Format will auto-
matically appear on the message display. Format the memory card. See "Format-
ting a Memory Card", page 3-45.
Press [MENU].
Press
(Report, in this example).
Press
Press
Press [OK]. A question mark (?) appears.
Press [OK]. Processing appears, then Waiting.
Send the file from the computer to the printer.
As the printer receives data, the message display changes to Processing, then
when the end of the data is received, the message display changes to Waiting.
or repeatedly until Memory Card > appears.
.
or repeatedly until >Read Data appears (Report, in this example).
or to display the desired data name.
or repeatedly until Memory Card > appears.
.
or repeatedly until >Write Data appears.
3-43
Using the Operator Panel