Input Presets Menu - Extron electronics mediaport 200 User Manual

Performing Auto-Image
When you perform Auto-Image, the MediaPort 200 attempts to size and position the image
to fill the display screen (fill mode) or to use the native aspect ratio of the input (follow mode).
Using SIS commands or the LCD menus, you can perform a one-time Auto-Image on the
current input.
Only the horizontal and vertical positioning and the horizontal and vertical size are adjusted
by the Auto-Image. All other controls are left unchanged.
• If the aspect ratio has been set to
and V Size is set to match the current output rate.
• If the aspect ratio has been set to
maintain the native aspect ratio of the input rate with respect to the current output
resolution.
Auto-Image is useful in applications in which a variety of new input sources may be
encountered (such as when a matrix switcher is connected). It is also useful for centering
and sizing an image that has been adjusted out of default settings.
You can perform an Auto-Image by the following methods:
LCD Menus
•
1. Press the front panel
2.
Press the
3. Rotate either
4. Press
5. Press
displays
After approximately 2 seconds, the screen displays the next menu (
EDID
• SIS commands — Enter
See the

Input Presets Menu

Input (user image) presets save the video settings for the current input. Each input has 16
available user image presets to which you can save settings or recall using this menu or
an SIS command (see the
following settings are saved in a user image preset:
• Preset name
• Contrast
• Brightness
• Horizontal position
Saved user image presets can be recalled to be applied to the current input.
Fill
Follow
button once to display the
Menu
button once to display
Next
knob to select
Adjust
. The LCD screen displays
Next
again. When the Auto-Image process is finished, the LCD screen
Next
Auto-Image Complete
). After another 30 seconds, the default cycle is displayed.
, using a communication tool such as Extron DataViewer.
A
Auto-Image commands
on page 53 for more information.
Input (User Image) Presets commands
• Vertical position
• Horizontal size
• Vertical size
, the H and V position returns to 0,0, and the H
, the H and V position and size are set to
Quick Setup
.
Auto-Image
.
<Yes>
Press Next to Start Auto-Image
.
MediaPort 200 • Operation
menu.
.
HDMI Input
on page 56). The
29