Glove Box - Dodge ram truck 3500 1996 Service Manual

m - M INSTRUMENT PANEL SYSTEMS BR
REMOVAL AND INSTALLATION
( C o n t i n u e d )
(2) Twist the lamp socket assembly to remove it
from the printed circuit board on the rear of the mes­
sage center housing.
(3) Remove the bulb from the lamp socket.
(4) Install the correct replacement bulb into the
lamp socket.
(5) Reverse the removal procedures to install.
HEADLAMP SWITCH
WARNING: IF THE HEADLAMP SWITCH WAS
TURNED ON, WAIT FIVE MINUTES TO ALLOW THE
CERAMIC PANEL LAMPS DIMMER RESISTOR TO
COOL. IF T H E RESISTOR IS NOT ALLOWED TO
COOL, IT CAN BURN YOUR FINGERS,
(1) Remove the cluster bezel as described in this
group.
(2) Remove the three screws securing the head­
lamp switch bezel to the instrument panel (Fig. 29).
KNOB A N D
STEM
J948E-16
Fig. 30 Headlamp Switch Knob and Stem Remove/
Install
OVERDRIVE LOCKOUT/FOG LAMP
SWITCH BEZEL
Fig. 29 Headlamp Switch and Bezel Remove/install
(3) Remove the headlamp switch and bezel from
the instrument panel.
(4) Unplug the two harness connectors from the
headlamp switch (Fig. 30).
(5) Pull the headlamp switch knob and stem
assembly out to its stop. Depress the release button
on the bottom of the switch housing and remove the
knob and stem from the switch.
(6) Remove the two screws and the switch bezel
from the housing.
(7) Reverse the removal procedures to install.
OVERDRIVE LOCKOUT/FOG LAMP SWITCH
(1) Remove the cluster bezel as described in this
group.
(2) Remove the three screws from the switch bezel
and remove the switch and bezel unit from the
instrument panel (Fig. 31).
J958E-47
Fig. 31 Overdrive Lockout/Fog Lamp Switch
Remove/Install
(3) From the rear of the switch and bezel unit, pull
up on the retaining tab(s) and unplug the electrical
connector(s).
(4) Release the retaining tabs and remove the
switch(es) from the rear of the bezel.
(5) Reverse the removal procedures to install.
GLOVE BOX
(1) Open the glove box door. Depress the right side
of the glove box bin far enough to allow the door stop
to clear the glove box opening (Fig. 32).
(2) From inside of the glove box, push on the stem
of the button holding the retaining strap at the left
end of the door. The button will push out allowing
the strap to be removed.
(3) The glove box door and bin are removed by lift­
ing the door off of the hinges (Fig. 33).
(4) Reverse the removal procedures to install.