Dodge ram truck 3500 1996 Service Manual page 533

BR
POWER MIRROR SYSTEMS 8T - 3
R E M O V A L
AND INSTALLATION
(Continued)
(6) Unplug
the wiring connectors from the
switches (Fig. 6).
CONNECTOR
LOCKING
TABS
SWITCH PANEL
FRONT CLIP
J948S-8
Fig. 6 Door Switch Connectors
(7) Pull the power mirror switch control knob rear­
ward to remove it from the switch stem (Fig. 7).
DOOR TRIM
PANEL
SWITCH CONTROL
KNOB
POWER MIRROR
- SWITCH — ?
J948T-6
Fig. 7 Power Mirror Switch Knob Remove/install
(8) Remove the mirror switch retaining nut from
the switch (Fig. 8).
(9) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
SWITCH RETAINING
NUT
DOOR TRIM-
PANEL
POWER MIRROR
SWITCH
J948T-5
Fig. 8 Power Mirror Switch Nut
(10) Unplug the power mirror switch wiring con­
nector (Fig. 9).
J948T-4
Fig. 9 Power Mirror Switch Connector
(11) Remove the power mirror switch from the
door trim panel.
(12) Reverse the removal procedures to install.