Specifications; Starting System - Dodge ram truck 3500 1996 Service Manual

8B - 1 0 STARTING SYSTEMS B R
R E M O V A L A N D I N S T A L L A T I O N ( C o n t i n u e d )
STARTER RELAY
(1) Disconnect and Isolate the battery negative
cable(s).
(2) Remove the cover from the Power Distribution
Center (PDC) (Fig. 16).
(3) Refer to the label on the PDC for starter relay
identification and location.
(4) Remove the starter relay by unplugging i t from
the PDC.
(5) Install the starter relay by aligning the relay
terminals with the cavities in the PDC and pushing
the relay firmly into place.
(6) Install the PDC cover.
(7) Connect the battery negative cable(s).
(8) Test the relay operation.
Fig. 16 Power Distribution Center
S P E C I F I C A T I O N S
STARTING SYSTEM
Starter and Solenoid
Engine Application 3.9L, 5.2L, 5.9L (Gas) 8.0L 5.9L (Diesel)
Manufacturer Nippon Denso Nippon Denso Nippon Denso
Part Number
56027702
56004757
4 7 4 1 0 " ! . ?
Power Rating i .4 Kilowatt 1.4 Kilowatt 2.7 Kilowatt
Voltage 12 Volts 12 Volts 12 Volts
Number of Fields 4
4
4
Number of Poles 4 4 4
Number of Brushes 4 4 4
Drive Type Reduction Gear Train Reduction Gear Train Conventional Gear Train
Free Running Test
Voltage
11 Volts 11 Volts 11 Volts
Free Running Test
Amperage Draw
73 Amperes 73 Amperes 200 Amperes
Free Running Test
Minimum Speed
3601 rpm 3601 rpm 3000 rpm
Solenoid Closing Voltage
7.5 Volts 7.5 Volts 8.0 Volts
Cranking Amperage
Draw Test*
125 - 250 Amperes 125 - 250 Amperes 450 - 700 Amperes
"Test at operating temperature. Cold engine, tight (new) engine, or heavy oil will increase starter amperage draw