B R
LAMPS
8L - 1 3
R E M O V A L A N D I N S T A L L A T I O N ( C o n t i n u e d )
Fig. 5 Side Identification Lamps
INSTALLATION
Reverse the removal procedure.
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMPS—PICKUP
REMOVAL
(1) Release tailgate latch and open tailgate.
(2) Remove screws holding tail lamp to cargo box
(Fig. 6).
(3) Grasp lamp, firmly pull lamp rearward to dis
engage retaining studs.
(4) Remove socket from tail lamp.
(5) Separate tail lamp from cargo box.
(6) Separate tail lamp from vehicle.
RETAINING
STUDS
J948L-6
Fig. 6 Tail Lamp Assembly
INSTALLATION
(1) Install socket in tail lamp.
(2) Position tail lamp in cargo box, engage retain
ing studs and install screws.
(3) Close tailgate.
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMPS—CHASSIS CAB
REMOVAL
( 1 ) Remove nuts * holding tail lamp to mounting
bracket (Fig. 7 ) .
(2) Disengage tail lamp wire connector from body
wire harness.
(3) Separate tail lamp[ from vehicle.
LICENCE
PLATE BRACKET
BRACKET
*
J948L-9
Fig. 7 Tail, Stop, Turn Signal and Back-up
Lamps—
Cab
Chassis
INSTALLATION
Reverse the removal procedure.
REAR IDENTIFICATION (ID) LAMPS
REMOVAL
Individual lamps may be replaced by removing the
lamp from the light bar.
( 1 ) Remove screws holding rear ID lamps to tail
gate (Fig. 8).
(2) Separate ID lamps from tailgate.
(3) Disengage ID lamp wire connector from body
wire harness.
(4) Separate ID lamp from vehicle.
INSTALLATION
Reverse the removal procedure.