8D - 28
IGNITION SYSTEM
BR
REMOVAL AND INSTALLATION (Continued)
(4) Remove ignition switch mounting screws. Use
tamper proof torx b i t Snap-on TTXR20A2 or equiva
lent to remove the screws (Fig. 66) or (Fig. 67).
Fig. 66 Ignition Switch Screw
Removal
SWITCH
958D-61
Fig. 67 Ignition Switch Screw
Removal
(5) Gently pull switch away from column. Release
connector locks on 7-terminal wiring connector, then
remove connector from ignition switch.
(6) Release connector lock on 4-terminal connector,
then remove connector from ignition switch (Fig. 68).
(7) To remove key cylinder from ignition switch:
KEY-IN SWITCH &
MULTI-FUNCTION
Fig. 68 Key-ln-Switch
and Halo Lamp
Connector
(a) Insert key in ignition switch. Turn key to
LOCK position. Using a TTXR20A2 or equivalent
torx bit, remove key cylinder retaining screw and
bracket (Fig. 69) or (Fig. 70).
(b) Rotate key clockwise to the OFF position.
Key cylinder will unseat from ignition switch (Fig.
71). When key cylinder is unseated, it will be
approximately 1/8 inch away from ignition switch
halo light ring. Do not attempt to remove key
cylinder at this time.
(c) With key cylinder in unseated position, rotate
key counterclockwise
to the lock position and
remove key.
958D-62
Fig. 69 Key Cylinder Retaining
Screw