Dodge ram truck 3500 1996 Service Manual page 504

8L - 14 LAMPS
BR
REMOVAL AND INSTALLATION (Continued)
BUMPER
SCREW
TAILGATE
MARKER LAMPS
J 9 4 8 L - 1 0
Fig. 8 Rear identification Lamps
LICENSE PLATE LAMP
REMOVAL
(1) Remove screws holding license plate panel to
cargo box.
(2) Disengage license plate lamp wire connector
from body wire harness (Fig. 9).
(3) Separate license plate lamp from vehicle.
INSTALLATION
Reverse the removal procedure.
DOME LAMP
REMOVAL
(1) Using a suitable flat blade screw driver, pry
dome lamp lens from dome lamp.
(2) Remove screws holding dome lamp to roof rein­
forcement (Fig. 10).
(3) Separate dome lamp from roof.
(4) Disengage dome lamp wire connector from body
wire harness.
(5) Separate dome lamp from vehicle.
INSTALLATION
(1) Position dome lamp at headliner.
(2) Connect dome lamp wire connector to body
wire harness.
(3) Install screws holding dome lamp to roof rein­
forcement (Fig. 10).
LAMP
PANEL
S C R E W
BUMPER
LICENSE
PLATE
LAMP
J948L-7
Fig. 9 License Plate Lamp Panel
(4) Place dome lamp lens on dome lamp and snap
into place.
DOME LAMP
H O U S I N G
DOME LAMP
LENS
J948L-5
Fig. 10 Dome Lamp
OVERHEAD CONSOLE READING LAMP
To service overhead console refer to Group 8C,
Overhead Console.