Vacuum Reservoir; Vehicle Speed Sensor - Dodge ram truck 3500 1996 Service Manual

B R — VEHICLE SPEED CONTROL SYSTEM 8H - 1 3
R E M O V A L A N D I N S T A L L A T I O N ( C o n t i n u e d )
VACUUM RESERVOIR
Fig 14 Servo Cable—Diesel Engine
L
mEmOWAL/mSTMLLMTIOm
(1) Lift wiper arm to permit the latch (Fig. 15) to
be pulled out to the holding position. Remove arms
from pivots using a rocking motion.
CAUTION: The use of a screwdriver or other pry­
ing tool to remove a wiper arm may distort it. This
distortion could allow the arm to come off the pivot
shaft, regardless of how carefully it is installed.
U N L O C K E D
POSITION
LOCKED
POSITION
J948K-21
Fig. 15 Removing Wiper Arms
(2) Remove weather-strip along front edge of cowl
screen (Fig. 16).
(3) Release plastic anchor screws (Fig. 17).
(4) Move cowl screen aside far enough to access
reservoir in right cowl plenum area.
(5) Remove 2 push nuts and slide vacuum reser­
voir off studs (Fig. 18).
J948K-3
Fig. 16 Cowl Screen Weatherstrip
(6) Disconnect all hoses.
(7) Reverse removal procedures to install. Refer to
Group 8K, Wiper and Washer Systems for correct
indexing of wiper arms.
VEHICLE SPEED SENSOR
For Removal/Installation of the Vehicle Speed Sen­
sor refer to Group 14, Fuel System.
S P E C I F I C A T I O N S
TOROUE SPECIFICATIONS
Description Torque
Servo Mounting Bracket Nuts. . .8.5 N-m (75 in. lbs.)
Switch Module Mounting
Screws 1.5 N-m (15 in. lbs.)